Parameters of Adec LSH series standard linear slide rails:

1. With automated, psychological capability

The X-shaped (forty five ° – 45 °) arc-shaped wave channel groove is designed in entrance to make it have the potential of automated centering. Even if there is a small error in the installation area, it can also be absorbed by the slide block to maintain substantial-precision, sleek and steady straight-line motion.

two. Layout of large rigidity and four route equal load

4 rows of metal balls and raceway 45 are utilised. With the speak to angle style, the steel ball can attain the excellent two-point contact, and can bear the positive and negative forces from the radial and lateral directions. If necessary, the metal ball can also be used with preload to enhance the rigidity.

3. It has interchangeability

Due to the rigid manage of production and production precision, the dimensional precision can be preserved in a steady tolerance range, and the slider has cage design to avert the metal ball from falling off. Therefore, when assembling the interchangeable variety line rail, the slider can be arbitrarily assembled on the very same variety of slide rail, and its smoothness, preloading and precision can be preserved.

Set up guidelines

one. Allowable mistake of installation surface

LSH series is a two-position make contact with linear slide rail with the qualities of automatic centering, which can take up some mistakes of the mounting area with no impacting the smoothness of linear motion. The allowable mistakes of the set up surface area are indicated in the subsequent table:

2. Datum plane top

In get to ensure the specific combination of linear slide rail and assembly components, the fillet ought to not exceed the suggested size. Remember to refer to the desk below for the specification and shoulder peak.

3. Recommended installation torque of slide rail finish wire