Parameters of Adec LSH collection standard linear slide rails:

1. With computerized, mental capacity

The X-shaped (45 ° – forty five °) arc-formed wave channel groove is made in entrance to make it have the potential of automated centering. Even if there is a little mistake in the installation floor, it can also be absorbed by the slide block to keep higher-precision, smooth and stable straight-line motion.

2. Design and style of substantial rigidity and four route equivalent load

Four rows of steel balls and raceway 45 are utilised. With the get in touch with angle style, the steel ball can reach the best two-stage speak to, and can bear the optimistic and adverse forces from the radial and lateral directions. If essential, the metal ball can also be applied with preload to enhance the rigidity.

3. It has interchangeability

Thanks to the strict management of manufacturing and manufacturing accuracy, the dimensional precision can be taken care of inside a secure tolerance range, and the slider has cage layout to prevent the steel ball from falling off. Therefore, when assembling the interchangeable variety line rail, the slider can be arbitrarily assembled on the same type of slide rail, and its smoothness, preloading and precision can be taken care of.

Set up instructions

one. Allowable mistake of set up area

LSH collection is a two-position speak to linear slide rail with the attributes of automated centering, which can take up some glitches of the mounting area with no influencing the smoothness of linear movement. The allowable glitches of the installation area are indicated in the following table:

two. Datum airplane top

In buy to guarantee the specific combination of linear slide rail and assembly elements, the fillet ought to not exceed the advisable measurement. Please refer to the table below for the specification and shoulder height.

three. Suggested set up torque of slide rail conclude wire