Parameters of Adec LSH series common linear slide rails:

1. With automated, mental capability

The X-formed (forty five ° – forty five °) arc-shaped wave channel groove is designed in entrance to make it have the potential of computerized centering. Even if there is a minor mistake in the installation area, it can also be absorbed by the slide block to keep high-precision, clean and secure straight-line motion.

two. Layout of higher rigidity and four route equivalent load

Four rows of steel balls and raceway forty five are employed. With the make contact with angle design and style, the steel ball can attain the best two-position make contact with, and can bear the optimistic and unfavorable forces from the radial and lateral directions. If essential, the metal ball can also be utilized with preload to improve the rigidity.

three. It has interchangeability

Because of to the strict management of manufacturing and manufacturing accuracy, the dimensional precision can be maintained inside of a secure tolerance selection, and the slider has cage layout to avert the metal ball from slipping off. Therefore, when assembling the interchangeable kind line rail, the slider can be arbitrarily assembled on the identical variety of slide rail, and its smoothness, preloading and precision can be managed.

Set up recommendations

1. Allowable error of set up surface area

LSH series is a two-point speak to linear slide rail with the attributes of automated centering, which can absorb some mistakes of the mounting surface without impacting the smoothness of linear movement. The allowable errors of the installation surface are indicated in the following table:

two. Datum airplane top

In order to make certain the exact combination of linear slide rail and assembly elements, the fillet need to not exceed the advisable size. Remember to refer to the table beneath for the specification and shoulder peak.

3. Recommended set up torque of slide rail end wire