Self-locking momentary Latching Push Button Swap

Operate of press button change
Reset – press the power to launch the electrical power OFF- (0N)
Self latching – simply click on electricity and then push the electrical power 0FF-0N

Application:
Audio / Movie item: MP3, MP4, DVD, stereo program
Digital devices: electronic digicam, electronic video clip
Distant handle: Vehicle, rolling door, Residence stability goods
JCPT goods: mobiles, automobile telephone, telephone, constructing equipment, PDA and so forth.
House Appliances: Tv, microwave oven, electric powered cooker, electrical hair drier, digital scale, Entire body Fat &Water Scale, Kitchen Scale.
Safety Merchandise: Videophone, Check and so forth.
Toy: electronic toy etc.
Pc items: Camera, recording pen and so forth.
Health products: managing device, massage chair, timer and many others.
JCPT Gear: sphygmomanometer, thermometer, the hospital contact program and other equivalent items.

Soldering
1. Standard Safeguards
Before soldering the Switch on a multilayer PCB, examination to verify that soldering can be carried out appropriately. In any other case the Change may be deformed by the soldering warmth on the pattern or lands of the multilayer PCB. 
Do not solder the Change much more than twice, including rectification soldering. An interval of 5 minutes is required in between the initial and next soldering.

two. JCPTmatic Soldering Baths 
Soldering temperature: 260°C max.
Soldering time: five s max. for a one.6-mm thick single-facet PCB
Preheating temperature: 100°C max. (ambient temperature)
Preheating time: Inside of 60 s
Make positive that no flux will increase above the degree of the PCB. If fluxoverflows on to the mounting surface of the PCB, it might enter the Switch and result in a malfunction. 

three. Reflow Soldering (Area Mounting)
Solder the terminals inside of the heating curve demonstrated in the adhering to diagram.
Be aware: The previously mentioned heating curve applies if the PCB thickness is one.6 mm.
The peak temperature could vary relying on the reflow tub employed. Verify the problems beforehand.
Do not use an automated soldering tub for floor-mounted Switches. The soldering fuel or flux might enter the Swap and hurt the Switch’s press-button procedure. 

four. Manual Soldering (All Designs)
Soldering temperature: 350°C max. at the tip of the soldering iron
Soldering time: 3 s max. for a one.six-mm thick, single-aspect PCB
Prior to soldering the Swap on a PCB, make confident that there is no needless room between the Swap and the PCB.