Parameters of Adec LSH series regular linear slide rails:

1. With computerized, psychological ability

The X-shaped (forty five ° – 45 °) arc-formed wave channel groove is created in front to make it have the capability of automatic centering. Even if there is a small error in the installation surface, it can also be absorbed by the slide block to maintain higher-precision, sleek and secure straight-line movement.

2. Design of high rigidity and four course equivalent load

4 rows of metal balls and raceway forty five are utilised. With the speak to angle layout, the steel ball can get to the best two-stage get in touch with, and can bear the good and adverse forces from the radial and lateral instructions. If essential, the metal ball can also be applied with preload to enhance the rigidity.

three. It has interchangeability

Due to the rigorous management of production and production accuracy, the dimensional precision can be preserved in a stable tolerance range, and the slider has cage layout to stop the steel ball from falling off. Consequently, when assembling the interchangeable sort line rail, the slider can be arbitrarily assembled on the very same sort of slide rail, and its smoothness, preloading and precision can be maintained.

Installation directions

one. Allowable error of set up floor

LSH sequence is a two-stage make contact with linear slide rail with the traits of automatic centering, which can absorb some problems of the mounting area without impacting the smoothness of linear motion. The allowable errors of the installation area are indicated in the adhering to desk:

2. Datum plane top

In purchase to make sure the exact mixture of linear slide rail and assembly parts, the fillet must not exceed the recommended measurement. Make sure you refer to the table under for the specification and shoulder top.

3. Advised set up torque of slide rail end wire